Description |
• |
The sensor used is a thermistor (NTC) in which resistance changes with temperature variation. |
• |
The TCM supplies about 5 voltage to the sensor; the output value is changed by ATF temperature variation. |
• |
Oil temperature sensor is installed at valve body. The sensor is integrated with a solenoid valve harness. |
• |
Transaxle oil temperature sensor monitors the temperature of ATF and conveys the readings to TCM. |
• |
Data produced by this sensor is used to identify torque
converter clutch activation and deactivation zones within the low
temperature and high temperature range and to compensate hydraulic
pressure levels during gear changes. |
Inhibitor Switch Repair procedures
Inspection
Power Circuit Inspection
1.
Disconnect the Inhibitor switch connector.
2.
Ignition KEY "ON"" & Engine "OFF"..
3.
Measure voltage between supplied power and ground at inhi ...
General Information
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Check the battery for damage, state of charge, and clean and tight c ...