Kia Sedona: Rear Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Kia Sedona YP Service ManualKia Sedona: Rear Wheel Speed Sensor Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor Repair procedures

Removal
1.
Remove the rear wheel speed sensor connector (A).

2.
Remove the rear wheel speed sensor.
(Refer to Driveshaft and Axle - "Rear Hub - Carrier")
3.
Install in the reverse order of removal.
Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Yaw-rate and G Sensor Description and Operation
Description The yaw rate and G sensor is included inside the air bag control module (SRSCM). When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate ...

Other Information:

Inhibitor Switch Description and Operation
Description • The inhibitor switch is installed on top of transaxle, and is connected to the shift lever through shift cable. • Inhibitor switch signals (S1, S2, S3, S4) are t ...

Blind Spot Detection Unit Repair procedures
Removal Blind spot detection (BSD) unit 1. Disconnect the negative (-) battery terminal.     Be careful when removing the blind spot detection unit. The bracket may brea ...

Categories


Copyright © www.kisedona.com 2016-2024