Kia Sedona: Overhead Console Lamp Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the overhead console lamp (A) after loosening the screws.

3.	Disconnect the connector (A) from the overhead console lamp.

Bulb Replacement

1.	Detach the overhead console lamp lens (A) from the overhead console lamp with a flat-tip screwdriver.

2.	Disconnect the overhead console lamp bulb (A).

Installation

1.	Connect the overhead console lamp connector.

2.	Install the overhead console lamp.

3.	Connect the negative (-) battery terminal.

Inspection

1.	Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Personal Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the personal lamp (A) using a flat-tip screwdriver. 3. Disconnect the personal lamp connector (A). Installation 1. C ...

Hazard Lamp Switch Repair procedures

Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. Connector Pin Information No.DescriptionNo.Description1ILL+ (TAIL)2 ...

Other Information:

Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates : Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there ...

Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high-pitched warning sound from your front brakes or rear brakes. You may hear this sound come and go or it may occur whene ...

Kia Sedona: Overhead Console Lamp Repair procedures

Personal Lamp Repair procedures

Hazard Lamp Switch Repair procedures

Other Information:

Categories