Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear spoiler.
(Refer to Body - "Rear Spoiler") |
3. |
Remove the high mounted stop lamp assembly (A) after loosening nuts. |
Installation |
1. |
Install the high mounted stop lamp. |
2. |
Install the rear spoiler. |
3. |
Connect the negative (-) battery terminal. |
Intake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when 12V is connected to termina ...
Inhibitor Switch Repair procedures
Inspection
Power Circuit Inspection
1.
Disconnect the Inhibitor switch connector.
2.
Ignition KEY "ON"" & Engine "OFF"..
3.
Measure voltage between supplied power and ground at inhi ...