Kia Sedona: Starting the engine - Key positions - Driving your vehicle - Kia Sedona YP Owners ManualKia Sedona: Starting the engine

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Driving your vehicle / Key positions / Starting the engine

WARNING - Proper footwear

Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots,etc.) may interfere with your ability to use the brake and accelerator pedal.

1. Make sure the parking brake is applied.

2. Place the transaxle shift lever in P (Park). Depress the brake pedal fully.

You can also start the engine when the shift lever is in the N (Neutral) position.

3. Turn the ignition switch to START and hold it there until the engine starts (a maximum of 10 seconds), then release the key.

It should be started without depressing the accelerator.

4. Do not wait for the engine to warm up while the vehicle remains stationary. Start driving at moderate engine speeds. (Steep accelerating and decelerating should be avoided.)

WARNING - Steering wheel

Never reach for any controls through the steering wheel while the vehicle is in motion. The presence of your hand or arm in this area could cause a loss of vehicle control.

If the engine stalls while you are in motion, do not attempt to move the shift lever to the P (Park) position. If traffic and road conditions permit, you may put the shift lever in the N (Neutral) position while the vehicle is still moving and turn the ignition switch to the START position in an attempt to restart the engine.

CAUTION - Starter

Do not engage the starter for more than 10 seconds. If the engine stalls or fails to start, wait 5 to 10 seconds before reengaging the starter. Improper use of the starter may damage it.

Ignition switch position
LOCK The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position. ACC (Accessory) The steering wheel is unlocked and electrical ac ...

Engine START/STOP button
...

Other Information:

Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will in ...

Power Door Mirror Switch Repair procedures
Inspection [Power Mirror Switch (Non-IMS] 1. Disconnect the negative (-) battery terminal. 2. Remove the front left door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the power ...

Categories


Copyright В© www.kisedona.com 2016-2024