1. Open the tailgate.
2. Loosen the lamp assembly retaining screws with a philips head screwdriver.
3. Remove the rear combination lamp assembly from the body of the vehicle.
4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
6. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
7. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
8. Reinstall the light assembly to the body of the vehicle.
* If your vehicle is equipped with LED type stop and tail lights replace with LED assembled units. Please contact an authorized Kia dealer.
Type B (Stop and tail lamp)
If the lamp bulb does not operate, have the vehicle checked by an authorized Kia dealer.
Auto Defogging Sensor (DATC only) Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal to blow out wind for defogging
if moisture occurs. On receiving the signal from ...
Components and Components Location
Components (1)
[General Type]
1. Roof trim2. Sunvisor [LH]3. Sunvisor [RH]4. Retainer
Components (2)
[Panorama sunroof Type]
1. Roof trim2. Sunvisor [LH]3. Sunvisor [RH]4. Retainer
...