The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal to blow out wind for defogging
if moisture occurs. On receiving the signal from the sensor, the air
conditioner control module restrains moisture and eliminates fog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect ambient temperature sensor.
4.
Check the resistance of the ...
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging se ...
Other Information:
Hazard Lamp Switch Repair procedures
Inspection
1.
Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.
Connector Pin Information
No.DescriptionNo.Description1ILL+ (TAIL)2 ...
Center Pillar Trim Repair procedures
Replacement
[Center pillar lower trim]
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related ...