Kia Sedona: Barometric Pressure Sensor (BPS) Specifications - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Barometric Pressure Sensor (BPS) Specifications

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Specifications

Specification
Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Ref=5V]
10.0 (0.01, 0.15)
0.50
55.0 (0.56, 7.98)
2.21
115.0 (1.17, 16.9)
4.50

ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2 ...

Barometric Pressure Sensor (BPS) Description and Operation
Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assemby. It senses absolute pressure of the air cleaner assemby and transfers the ...

Other Information:

Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator () goes off after blinking 5 times, your transponder equipped in the ignition key is out of order. You cannot sta ...

Description and Operation
Description BSD system uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the following vehicles and provide sensing and (visual and auditory) alarms f ...

Categories


Copyright © www.kisedona.com 2016-2024