Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control
system.
If there is no CKPS signal input, the engine may stop due to lack of fuel supply and relay inoperation.
This sensor is installed on the cylinder block or the
transaxle housing and generates alternating current by magnetic flux
field which is made by the sensor and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 empty slots on 360 degrees CA (Crank Angle).
Seat Belt Buckle Switch (BS) Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work.
2.
Remove the front seat assembly.
(Refer to Body - "Front seat")
3.
Loosen th ...
Repair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) clearance by moving it up and down, or left and right.
2.
Adjust the hood height by turning the hood overslam bum ...