Kia Sedona: Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams

Circuit Diagram

Engine Coolant Temperature Sensor (ECTS) Description and Operation
Description Located in the engine coolant passage of the cylinder, the Engine Coolant Temperature Sensor (ECTS) is used to detect the engine coolant temperature. The ECTS uses a thermistor whos ...

Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coola ...

Other Information:

Wheel Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, fin ...

Noise and smoke
When inflated, the air bags make a loud noise and leave smoke and powder in the air inside the vehicle. This is normal and is a result of the ignition of the air bag inflator. After the air bag in ...

Categories


Copyright В© www.kisedona.com 2016-2025