Kia Sedona: External AMP Repair procedures - AVN System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: External AMP Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / AVN System / External AMP Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Remove the body control module.
(Refer to "BCM (Body Control Module)")
4.
Disconnect the external amplifier connector (A).

5.
Remove the external amplifier (A) after loosening the nuts.
   
Remove the external amp in the direction of the arrow.

Installation
1.
Install the external amplifier.
2.
Connect the external amplifier connector.
3.
Install the BCM (Body Conetrol Module).
4.
Install the main crash pad assembly.
5.
Connect the negative (-) battery terminal.
   
•
Make sure that the connectors are connected properly.
•
Check the AVN system.
External AMP Components and Components Location
Components Connector Pin Information No.Connector ANo.Connector B1Left front door (+)1Center front (+)2Right front door (+)2-3Left side door (+)3-4Right side door (+)4-5Subwoofer 2 (+)5Navi (+)6 ...

Speaker Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector ...

Other Information:

Rearview camera
The rearview camera will activate with the ignition switch ON and the shift lever in the R (Reverse) position This system is a supplemental system that shows behind the vehicle through the re ...

Transmitter precautions
The transmitter will not work if any of following occur : - The ignition key is in the ignition switch. - You exceed the operating distance limit (about 10 m [30 feet]). - The battery in the t ...

Categories


Copyright © www.kisedona.com 2016-2025