Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Remove the front door belt inside weatherstrip (A). |
3. |
Remove the front door window glass mounting hole plug (A). |
4. |
Before removing the front door glass (C), loosen the mounting
bolt (A) as loosely as possible and loosen the mounting bolt (B)
completely.
|
5. |
Carefully adjust the front door window glass (A) until the
bolts are visible, then loosen them. Separate the glass from the glass
run and carefully pull the glass out through the window slot.
|
6. |
Install in the reverse order of removal.
|
Air bag collision sensors
(1) SRS control module/ Rollover sensor
(2) Front impact sensor
(3) Side impact sensor
(4) Side pressure sensor
WARNING - Air bag sensors
Do not hit or allow any objects to impact the lo ...
Rear Door Latch Repair procedures
Replacement
[Front]
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Disconnect the rear door cable (A).
3.
Disconnect the rear door remote controller connector ...