If the vehicle needs to be towed, call a professional towing
service. Never tow vehicle with just a rope or chain. It is very
dangerous.
[Front]
[Rear]
Emergency Towing
There are three popular methods of towing a vehicle :
–
The operator loads the vehicle on the back of truck. This is best way of transporting the vehicle.
–
The tow truck uses two pivoting arms that go under the tires
of the driving axle and lift them off the ground. The other two wheels
remain on the ground.
–
The tow truck uses metal cables with hooks on the ends. These
hooks go around parts of the frame or suspension, and the cables lift
that end of the vehicle off the ground. The vehicle''s suspension and
body can be seriously damaged if this method of towing is attempted.
If the vehicle cannot be transported by flat-bed, should be
towed with the wheels of the driving axle off the ground and do the
following :
Manual Transaxle
•
Release the parking brake.
•
Shift the Transaxle to neutral
Automatic Transaxle
•
Release the parking brake.
•
Start the engine.
•
Shift to [D] position, then [N] position.
•
Turn off the engine.
•
The vehicle equipped with full-time 4WD should be only transported on a flat-bed.
•
Improper towing preparation will damage the transaxle. follow
the above procedure exactly. If you cannot shift the transaxle or start
the engine(automatic transaxle), your vehicle must be transported on a
flatbed.
•
It is the best to tow vehicle no farther than 30km (19miles),
and keep the speed below 50km/h (30mph). (For the full-time 4WD
vehicle, limit the towing to 1.5km (1mile) and 15km/h (10mph)
•
Trying to lift or tow your vehicle by the bumpers will cause
serious damage. The bumpers are not designed to support the vehicle''s
weight.
Components and Components Location
Components
1. Crash pad side cover [LH]2. Steering column shroud lower panel3. Crash pad lower panel4. Knee bolster panel5. Glove box6. Crash pad side cover [RH]7. Main crash pad assembly
...
Moving up a steep grade from a standing start
To move up a steep grade from a standing start, depress the brake pedal, shift
the shift lever to D (Drive). Select the appropriate gear depending on load weight
and steepness of the grade, and re ...