Kia Sedona: Glove Box Housing Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Disconnect the stopper (B) from the glove box (A).

2.	Disconnect the air damper (A) from the glove box (B).

3.	Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

4.	After loosening the mounting screws and bolts, remove the glove box housing (A).

Install in the reverse order of removal.

•	Make sure that the connectors are connected properly.

•	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Multi Box Components and Components Location

Component Location 1. Multi box ...

Other Information:

Engine number
The engine number is stamped on the engine block as shown in the drawing. ...

Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia upper panel. (Refer to Body - "Center Fascia Panel") 3. Remove the start/stop button (A) after looseni ...

Kia Sedona: Glove Box Housing Repair procedures

Glove Box Housing Components and Components Location

Multi Box Components and Components Location

Other Information:

Categories