Kia Sedona: Heated Oxygen Sensor (HO2S) Specifications - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Heated Oxygen Sensor (HO2S) Specifications

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Specifications

Specification
[Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
3.3 ~ 4.1[20°C(68°F)]

[Bank 1/Sensor 2]
Item
Specification
Heater Resistance (Ω)
3.3 ~ 4.1[20°C(68°F)]

[Bank 2/Sensor 1]
Item
Specification
Heater Resistance (Ω)
3.3 ~ 4.1[20°C(68°F)]

[Bank 2/Sensor 2]
Item
Specification
Heater Resistance (Ω)
3.3 ~ 4.1[20°C(68°F)]

Knock Sensor (KS) Repair procedures
Removal [Bank 1] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") ...

Heated Oxygen Sensor (HO2S) Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of the zirconium and the alumina and is installed on upstream and downstream of the Warm-up Catalytic Converter (WCC). After it compares oxygen ...

Other Information:

Air intake control
Type A The air intake control is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, press the control button. Recirculated ...

Warning indicator
Warning message Master warning light When the LDWS is not working properly, the warning light will illuminate and the warning message will come on for a few second. After the message disappear ...

Categories


Copyright © www.kisedona.com 2016-2025