Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Install the driver''s door trim.
(Refer to Body - "Front Door Trim") |
3. |
Remove the IMS switch (A) after loosening the screws. |
Installation |
1. |
Install the IMS switch. |
2. |
Install the driver''''s door trim. |
3. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
Remove the memory power seat connector. |
2. |
When each switch is pressed, check the electricity flow
between memory power seat switch connector and grounding, and if the
electricity does not match the specification, replace the switch. |
Massage Control Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
3.
Disconnect the lumbar support motor connectors ( ...
Front windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...