Kia Sedona: In-car Sensor (DATC only) Description and Operation
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor (DATC only) Description and Operation
| Description |
The In-car air temperature sensor is built in the heater & A/C control unit.
The sensor consists of a thermistor that measures the inside
temperature. The signal decided by the resistance value that changes in
accordance with perceived inside temperature, is delivered to heater
control unit, and according to this signal, the control unit regulates
in-car temperature to intended value.
[AVN Type]
[AUDIO Type]
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistance between terminals “+” and “-” of the evaporator tempera ...
Photo Sensor Description and Operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light r ...
Other Information:
Photo Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will in ...
Latch Switch Repair procedures
Inspection
1.
When inspecting, use the inspection equipment to check for
input/output values at each position of Power Sliding Door control
module.
2.
To check the operation of latch, cho ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026