Kia Sedona: Inhibitor Switch Components and Components Location - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Inhibitor Switch Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Components and Components Location

Component Location

1. Inhibitor switch
2. Manual control lever

Inhibitor Switch Specifications
Specification ItemSpecificationPower supply (V)12Output typeCombination of output signals Signal Code Table  PP-RRR-NNN-DDSignal "1"12V12V00000Signal "2"012V12V12V000Signal "3"00012V12V12 ...

Inhibitor Switch Description and Operation
Description • The inhibitor switch is installed on top of transaxle, and is connected to the shift lever through shift cable. • Inhibitor switch signals (S1, S2, S3, S4) are t ...

Other Information:

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

Antenna Repair procedures
Inspection Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. 3. Check for continuity between the ...

Categories


Copyright © www.kisedona.com 2016-2025