1. Turn the ignition switch to the ON position.
2. Turn the fan speed control knob to the OFF (0) position.
3. Turn the mode selection knob to the defrost position ().
4. Push the air intake control button ()
at least 5 times within 3 seconds.
If the battery has been discharged or disconnected, it resets to the defog logic status.
Power Window Motor Repair procedures
Inspection
•
Wrap a protective tape around tools used in disassembling such as screwdriver or remover.
•
Use caution in keeping and handling during ...
Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia upper panel.
(Refer to Body - "Center Fascia Panel")
3.
Remove the start/stop button (A) after looseni ...