Kia Sedona: Rear Oil Seal Repair procedures
1.
Remove the transaxle assembly.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Remove the rear oil seal (A).
4.
Remove the rear oil seal case (A).
1.
Install the rear oil seal case (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
•
Clean the sealing face before assembling two parts.
•
Remove harmful foreign materials on the sealing face before applying sealant
•
Before assembling rear oil seal case, the liquid sealant TB1217H should be applied to the rear oil seal case.
•
Parts must be assembled within 5 minutes after applying the sealant.
•
Apply sealant to the inner threads of the bolt holes.
2.
Using SST (09231-3C200, 09231-H1100), install the rear oil seal.
Do not reuse the rear oil seal.
3.
Install the other parts in the reverse order of removal.
Components
1. Rear oil seal2. Oil seal case
...
Components
1. Piston ring2. Piston pin3. Snap ring4. Piston5. Connecting rod6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap
...
Other Information: Seat Heater Switch Schematic Diagrams
Circuit Diagram
[First Row Seat]
[Second Row Seat]
...
Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where
none of the following conditions apply. If any of the following conditions apply,
follow the Maintenance Under Sever ...