Kia Sedona: Repair procedures - Evaporative Emission Control System - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Repair procedures

Inspection
[EVAP. Leakage Test]
1.
Select "Evap. Leakage Test".

2.
Proceed with the test according to the screen introductions.

Schematic Diagrams
Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when ...

Canister Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - "Fuel Tank") 3. Disconnect the ...

Other Information:

Hood Insulator Pad Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Install ...

Sunroof
Front Rear If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, close ...

Categories


Copyright В© www.kisedona.com 2016-2025