Kia Sedona: Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2-8 cm (1 to 3 inches) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button (or press and
Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased) :
...
Canadian Programming Garage & gate openers
During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button (note steps 2 through 4 in the ...
Other Information:
Removal and reinstallation
To remove the headrest :
1. Raise it as far as it can go then press the release button (1) while pulling
the headrest up (2).
To reinstall the headrest :
1. Put the headrest poles (3) into the ...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1.6 mm (1/16 inch) of tread left
on the tire. Replace the tire when ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
