Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower switch (A) after loosening the mounting screws. |
4. |
Remove the rheostat switch connector (A). |
5. |
Check for intensity of rheostat switch. If the light
intensity of the lamps changes smoothly without any flickering when the
rheostat is turned on, it can be assumed that the rheostat is operating
normally. |
ETC (Electronic Throttle Control) System Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a
throttle body with an integrated control motor and throttle position
sensor (TPS). Instead of the traditional throttle cab ...
Rear Door Trim Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...