Kia Sedona: Rolling code programming

Third generation YP (2014-2026) / Kia Sedona YP Owners Manual / Features of your vehicle / Mirrors / Rolling code programming

Programming

Your vehicle may require the ignition switch to be turned to the ACC position for programming and/or operation of HomeLink. It is also recommended that a new battery be replaced in the hand-held t ...

Operating HomeLink

To operate, simply press the programmed HomeLink button. Activation will now occur for the trained product (garage door, security system, entry door lock, estate gate, or home or office lighting). ...

Other Information:

Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator () goes off after blinking 5 times, your transponder equipped in the ignition key is out of order. You cannot sta ...

Rear Door Latch Repair procedures
Replacement [Front] 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door cable (A). 3. Disconnect the rear door remote controller connector ...