Kia Sedona: Front Driveshaft Components and Components Location - Driveshaft Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: Front Driveshaft Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / Front Driveshaft Components and Components Location

Components

1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)

[LH]

1. BJ assembly
2. Clip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Circlip
12. TJ housing
13. Circlip

[RH]

1. BJ assembly
2. Clip 
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Circlip
12. TJ housing
13. Circlip

Driveshaft Assembly
...

Front Driveshaft Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to dam ...

Other Information:

OFF mode
Press the front blower OFF button to turn off the front air climate control system. However, you can still operate the mode and air intake buttons as long as the ignition switch is in the ON pos ...

Rear mode selection
Front climate control is : Rear air blows from the upper vents on the rear ceiling. Front climate control is : Rear air blows from the upper vents on the rear ceiling and the lower vents ...

Categories

Copyright © www.kisedona.com 2016-2026