Kia Sedona: Hood Latch Release Handle Components and Components Location

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Components and Components Location

Hood Weatherstrip Repair procedures

Replacement 1. Remove the glue on both ends (A) of the hood weatherstrip (B).     • Be careful not to scratch the hood weatherstrip. 2. Install in the r ...

Hood Latch Release Handle Repair procedures

Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off ...

Other Information:

Outside lamp
1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a philips head screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the so ...

Auto Light Sensor Repair procedures
Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor''s input (illuminat ...