Kia Sedona: Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Repair procedures

Adjustment

Glass Adjustment

Check the glass run channel for damage or deterioration, and replace if necessary.

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the rear door trim seal. (Refer to Rear Door - "Rear Door Window glass")

3.	Remove the rear door window glass mounting hole plug (A).

4.	Carefully move the rear door window glass (A) until the glass mounting bolts are visible, then loosen them.

5.	Check that the glass moves smoothly.

Door Striker Adjustment

Make sure that the door latches securely without slamming it. If necessary, adjust the striker (A) by moving it up and down or in and out before fixing the striker nuts.

Loosen the screws (B) just enough for the striker to move.

Tightening torque :

(B) : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)

2.	Lightly tap on the striker with a plastic hammer just enough to give some adjustment.

3.	Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.

Door Position Adjustment

After installing the door, check for a flush fit with the adjacent body panels, then check for equal gaps between the front, rear, and bottom, door edges and the body. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.

1.	Check that the door and body edges are parallel.

2.	Place the vehicle on a firm, level surface when adjusting the doors.

Adjust at the hinges (A):

•	Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.

•	Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.

•	Place a shop towel on the jack to prevent damage to the door when adjusting the door.

[Upper]

[Lower]

[Center]

4.	Check for water leakage.

Components and Components Location

Components 1. Rear door parting weatherstrip2. Rear door side weatherstrip3. Rear door inside handle cover4. Rear door trim5. Rear door belt inside weatherstrip6. Rear door upper opening weather ...

Rear Door Trim Components and Components Location

Component Location 1. Rear door trim ...

Other Information:

Temperature control
The temperature will increase to the maximum (HI) by turning the knob to the extreme right. The temperature will decrease to the minimum (Lo) by turning the knob to the extreme left. When turn ...

Hood Latch Release Handle Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A). • Use a 6mm hex bit to press the center until the handle easily pulls off ...

Kia Sedona: Repair procedures

Components and Components Location

Rear Door Trim Components and Components Location

Other Information:

Categories