Kia Sedona: Rear Door Belt Outside Weatherstrip Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Belt Outside Weatherstrip Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Outside Weatherstrip Repair procedures

Replacement
1.
Pull down rear door window glass by pressing the power window glass switch.
2.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Rear Door Latch Repair procedures
Replacement [Front] 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door cable (A). 3. Disconnect the rear door remote controller connector ...

Rear Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. ...

Other Information:

Closing the hood
1. Before closing the hood, check the following: All filler caps in the engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the ...

Components and Components Location
Components 1 Overhead console switch2 Power Sliding Door trim switch3 Inside/outside door handle switch 4 Latch (detent switch & primary switch included)5 Power Sliding Door drive unit 6 Powe ...

Categories


Copyright В© www.kisedona.com 2016-2024