Kia Sedona: Radiator Grill Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Disconnect the wiring fixing fastener (A).

3.	Remove the front bumper energy absorber (B).

4.	Loosen the screws and remove the radiator mesh (A).

5.	Loosen the screws and remove the radiator grill (A) from the front bumper.

6.	Loosen the screws and remove the radiator grill (A).

Install in the reverse order of removal.

Replace any damaged clips.

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Rear Bumper

...

Other Information:

Power tailgate non-opening conditions
The power tailgate will not open automatically, but will close under the following conditions. When the ignition switch is in the ON position, 1. Vehicle is moving above 3 km/h (2 mph). 2. The ge ...

Special Service Tools
Special Service Tools Tool Name / NumberIllustrationDescriptionCrankshaft front oil seal installer09231-3C100Ring gear stopper09231-2B100Used for keeping ring gear from rotating when removing / i ...

Kia Sedona: Radiator Grill Repair procedures

Radiator Grill Components and Components Location

Rear Bumper

Other Information:

Categories