Kia Sedona: IMS Control Switch Repair procedures
Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Control Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Install the driver''s door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Remove the IMS switch (A) after loosening the screws.
|
| Installation |
| 1. |
Install the IMS switch. |
| 2. |
Install the driver''''s door trim. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Remove the memory power seat connector.
|
| 2. |
When each switch is pressed, check the electricity flow
between memory power seat switch connector and grounding, and if the
electricity does not match the specification, replace the switch.
|
IMS Control Switch Components and Components Location
Components
...
Other Information:
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
On curves
On curves, the SCC may not detect a moving vehicle in your lane, and then
your vehicle could accelerate to the set speed. Also, the vehicle speed will
rapidly slow down when the vehicle ahead ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2025 Owners Manual
- Kia Sedona YP 2014-2025 Service Manual
Copyright В© www.kisedona.com 2016-2025