Kia Sedona: Rear Temperature Control Actuator Description and Operation
The heater unit consists of mode control actuator and temperature control actuator.
Located in the heater unit, the temperature control actuator regulates the temperature in the following procedure.
Signal from control unit adjusts the position of the
temperature door by operating the temperature switch. Then the
temperature will be regulated by the hot/cold air ratio decided by the
position of the temperature door.
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the actuator operates to the recirculation position when 12V is connect ...
Other Information:
Multi Box Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...
Safety chains
You should always attach chains between your vehicle and your trailer. Cross
the safety chains under the tongue of the trailer so that the tongue will not drop
to the road if it becomes separated ...