Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, move the lever to this (MIST/) position and release it. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.
LO : Normal wiper speed
HI : Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Smart Cruise Control Unit Description and Operation
Description
The smart cruise control unit is installed on the front
right-hand side of the chassis. A radar sensor is embedded in the front
section of the unit. This sensor detects vehicles and ...
Road warning
Type A
Type B
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever eme ...