Kia Sedona: AC inverter
The AC inverter supplies 115V/100W electric power to operate electric accessories
or equipments.
If you wish to use the AC inverter, press the AC inverter button while the engine
is running. The light on the AC inverter button will illuminate.
If you press the AC inverter button again, the AC inverter will be deactivated
and the light on the AC inverter button will turn off.
✽ NOTICE
When turning on the AC inverter, the indicator on the AC inverter button illuminates
late while the system conducts a self-check.
✽ NOTICE
- Rated voltage : AC 115V
- Maximum electric power : 100W
- In order to avoid an electrical system failure, electric shock, etc.,
be sure to read owner's manual before use.
- Be sure to close the cover except the time of use.
- To prevent the battery from being discharged, do not use the AC inverter
while the engine is not running.
- When not using the AC inverter, make sure to turn off the AC inverter
(the indicator on the button does not illuminate) and close the AC inverter
cover.
- After using an electric accessory or equipment, pull the plug out. Leaving
the accessory or equipment plugged in for a long time may cause battery discharge.
- Do not use an electric accessory or equipment the power consumption of
which is greater than 100W (115V).
CAUTION - Electric accessory devices
- Do not use broken electric accessories which may damage the AC inverter
and electrical systems of the vehicle.
- Do not use two or more electric accessories at the same time. It may
cause damage to the electrical systems of the vehicle.
Front
Rear
The power outlet is designed to provide power for mobile telephones or other
devices designed to operate with vehicle electrical systems. The devices should
draw less than 10 am ...
Front
Rear
The USB charger is designed to recharge batteries of small size electrical devices
using a USB cable.The electrical devices can be recharged when the Engine Start/Stop
button is i ...
Other Information:
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Me ...
Shift Lever Repair procedures
Removal
1.
Move the shift lever to "N" range.
2.
Disconnect the battery negative (-) cable.
3.
Remove the knob (A) and boots (B) by pulling them in the
direction of the arrow after separ ...