The system will activate when:
1.The system is on.
2.Vehicle speed is above 30 km/h (18.6 mph ).
3.Other vehicles are detected in the rear side.
WARNING
The Blind Spot Detection System with Lane Change Assist and Rear Cross Traffic Alert is not a substitute for proper and safe lane changing procedures. Always drive safely and use caution when changing lanes. The Blind Spot Detection System may not detect every object alongside the vehicle.
1st stage
If a vehicle is detected within the boundary of the system, a warning light will illuminate on the outside rearview mirror.
If the detected vehicle is not in detecting range, the warning will turn off according to driving conditions.
2nd stage
The second stage alarm will activate when:
1.The first stage alert is on
2.The turn signal is on to change a lane
When the second stage alert is activated, a warning light will blink on the outside rearview mirror and a alarm will sound.
If you move the turn signal switch to the original position, the second stage alert will be deactivated.
Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance
for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures
reco ...
Inhibitor Switch Description and Operation
Description
•
The inhibitor switch is installed on top of transaxle, and is connected to the shift lever through shift cable.
•
Inhibitor switch signals (S1, S2, S3, S4) are t ...