Kia Sedona: Reservoir Tank Repair procedures - Cooling System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Reservoir Tank Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cooling System / Reservoir Tank Repair procedures

Removal and Installation
1.
Disconnect the over flow hose (A), and then drain the coolant from the reservoir tank.
2.
Remove the reservoir tank (B).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Install in the reverse order of removal.
4.
Refill the coolant.
Radiator Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 3. Drain ...

Water Temperature Control Assembly Components and Components Location
Components 1. Water pipe 2. Throttle body coolant hose & pipe3. Water temperature control assembly4. O-ring ...

Other Information:

Defroster
CAUTION - Conductors To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the wind ...

Parking assist system
The Parking Assist System is not a substitute for proper and safe parking and backing-up procedures. Always drive safely and use caution when parking. The Parking Assist System may not detect ev ...

Categories

Copyright © www.kisedona.com 2016-2026