Kia Optima Manuals

Kia Sedona: Water Jacket Seperator Repair procedures - Cylinder Block - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Water Jacket Seperator Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Repair procedures

Removal
1.
Remove the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
2.
Remove the water jacket seperators (A).

Installation
1.
Install the #1, #2 cylinder bore water jacket seperators (A).

   
Insert the separator align into the block inner side protrusion making sure that it is located below the cylinder head installing surface.

2.
Install the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
Water Jacket Seperator Components and Components Location
Components 1. Water jacket separator ...

Drive Plate Components and Components Location
Components 1. Drive plate2. Adapter plate ...

Other Information:

Front Wiper Motor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm. 3 ...

Heated Oxygen Sensor (HO2S) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 3 and 4. 4. Check that the resistance is within the speci ...

Categories

Copyright © www.kisedona.com 2016-2026