Kia Sedona: Accelerator Position Sensor (APS) Description and Operation
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Description and Operation
| Description |
Accelerator Position Sensor (APS), installed on the
accelerator pedal module, detects the rotation angle of the accelerator
pedal. The APS, one of the most important sensors in engine control
system, consists of two sensors each equipped with individual sensor
power and ground lines. The second sensor monitors the first sensor and
its output voltage is half of the first one. If the ratio of the sensor 1
and 2 is out of the range (approximately 1/2), the diagnostic system
judges that it is abnormal.
Accelerator Position Sensor (APS) Specifications
Specification
AcceleratorPositionOutput Voltage (V) [Ref=5V]APS1APS2C.T0.7 ~ 0.80.29 ~ 0.46W.O.T3.85 ~ 4.351.93 ~ 2.18
...
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...
Other Information:
Check fuse BRAKE SWITCH (for smart key system)
This warning message illuminates if the brake switch fuse is disconnected.
It means that you should replace the fuse with a new one. If that is not
possible, you can start the engine by pres ...
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026