Kia Optima Manuals

Kia Sedona: Steering Column Shroud Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Steering Column Shroud Panel Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement
[Steering column shroud lower panel]
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Separate the steering column shroud upper panel (A).

2.
Loosen mounting screws on both sides.
[LH]

[RH]

3.
Loosen the mounting screw and remove the steering column shroud lower panel (A).

4.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
[Steering column shroud upper panel]
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the center fascia panel.
(Refer to Crash Pad - "Center Fascia Panel")
2.
Install in the reverse order of removal.
   
Replace any damaged clips.
Steering Column Shroud Panel Components and Components Location
Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

Crash Pad Side Cover Components and Components Location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

Other Information:

Air intake control
This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position With the reci ...

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DO NOT remove the cam ...

Categories


Copyright © www.kisedona.com 2016-2025