- The ignition key is in the ignition switch.
- You exceed the operating distance limit (about 10 m [30 feet]).
- The battery in the transmitter is weak.
- Other vehicles or objects may be blocking the signal.
- The weather is extremely cold.
- The transmitter is close to a radio transmitter such as a radio substation or
an airport which can interfere with normal operation of the transmitter.
CAUTION
Keep the transmitter away from water or any liquid as it can become damaged and not function properly.
✽ NOTICE
If the keyless entry system is inoperative due to exposure to water or liquids,
it will not be covered by your manufacturer Rear Seat Cushion Cover Components and Components Location Power Sliding Door (PSD) Control Module Repair proceduresPanic
The horn sounds and hazard warning lights flash for about 27 seconds if this
button is pressed for more than 0.5 second. To stop the horn and lights, press any
button on the transmitter. ...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Other Information:
Component Location
[Second Row Seat Assembly]
1. Second Row Seat Cushion Cover [RH]2. Second Row Center Seat Cushion Cover3. Second Row Seat Cushion Cover [LH]
1. Second Row Seat Cushion Co ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [LH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the power sliding door control module co ...