Kia Sedona: Engine Room Under Cover Components and Components Location - Engine And Transaxle Assembly - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Engine Room Under Cover Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine Room Under Cover Components and Components Location

Components

1. Engine room RH side cover
2. Engine room LH side cover
3. Engine room front under cover

Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A).     • Lift up the lower end of engine cover, then left and right alternately. • When install ...

Engine Room Under Cover Repair procedures
Removal Engine Room Front Under Cover 1. Remove the engine room front under cover (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 2. Install in the reverse or ...

Other Information:

CVVT Oil Temperature Sensor (OTS) Repair procedures
Inspection [Resistance Inspection] 1. Turn the ignition switch OFF. 2. Remove the OTS. (Refer to "Removal") 3. After immersing the thermistor of the sensor into engine coolant, measure ...

Auto Defogging Sensor (DATC only) Repair procedures
Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the auto defogging se ...

Categories


Copyright © www.kisedona.com 2016-2025