Kia Optima Manuals

Kia Sedona: Hands free switch Repair procedures - Hands Free System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Hands free switch Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Hands Free System / Hands free switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the steering wheel remote control switch (A) after loosening the screw.

4.
Disconnect the steering wheel remote control switch connector (A).

Installation
1.
Install the steering wheel remote control switch after connecting the connector.
   
Make sure that the switch connector is plugged in properly.
2.
Install the driver airbag module.
3.
Connect the negative (-) battery terminal.
Inspection
1.
Check for resistance between terminals in each switch position(LH).

Switch
Connector terminal
Resistance
(±5%)
END
3-8
1.11kΩ
SEND
3-8
430Ω
VOICE
3-8
18.81kΩ
MODE
4-8
6.71kΩ
SEEK UP
4-8
4.51kΩ
SEEK DN
4-8
2.11kΩ
MUTE
4-8
0

Diagnosis With GDS
1.
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point adjustment
The BCM communicates with the GDS and then reads the input/output value and drives the actuator.
2.
Select the ''Steering wheel remote control'' and the system to be checked in order to check the vehicle with the tester.
3.
Select the ''Steering wheel remote control (SWRC)'' to check the Steering wheel remote control (SWRC)
   
Select ''Sensor Data'' and ''Steering wheel remote control (SWRC)'' to check the Instrument Panel Module (Sensor Data).
4.
Select the "Current date" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the ''Premium AVN'' can be checked.
Hands free switch Schematic Diagrams
Circuit Diagram ...

Hands free mic Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp. (Refer to Body Electrical - "Overhead Console Lamp") 3. Remove the hands free mic (A) from ...

Other Information:

FCWS malfunction message
Warning message Master warning light When the FCWS is not working properly, the warning message will come on for a few second. After the message disappears, the master warning light will illum ...

Rear Transverse Trim Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...

Categories

Copyright © www.kisedona.com 2016-2026