Kia Sedona: Inside lamp - Rear combination lamp bulb replacement - Light bulbs - Maintenance - Kia Sedona YP Owners ManualKia Sedona: Inside lamp

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Maintenance / Light bulbs / Rear combination lamp bulb replacement / Inside lamp

Type A

Type B

1. Open the tailgate.

2. Remove the service cover.

3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

4. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

5. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

6. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.

7. Install the service cover by putting it into the service hole.

* If your vehicle is equipped with LED type stop and tail lights replace with LED assembled units. Please contact an authorized Kia dealer.

Outside lamp
1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a philips head screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the so ...

High mounted stop lamp replacement
1. Open the tailgate. 2. Gently remove the center cover of the rear tailgate trim. 3. Disconnect the electrical connector. 4. Loosen the retaining nuts and remove the spoiler. 5. Remove the ...

Other Information:

Pantoscopic Camera Components and Components Location
Components ...

Heated Oxygen Sensor (HO2S) Schematic Diagrams
Circuit Diagram ...

Categories


Copyright В© www.kisedona.com 2016-2024