Kia Sedona: Outside lamp - Rear combination lamp bulb replacement - Light bulbs - Maintenance - Kia Sedona YP Owners ManualKia Sedona: Outside lamp

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Maintenance / Light bulbs / Rear combination lamp bulb replacement / Outside lamp

1. Open the tailgate.

2. Loosen the lamp assembly retaining screws with a philips head screwdriver.

3. Remove the rear combination lamp assembly from the body of the vehicle.

4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

6. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

7. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.

8. Reinstall the light assembly to the body of the vehicle.

* If your vehicle is equipped with LED type stop and tail lights replace with LED assembled units. Please contact an authorized Kia dealer.

Type B (Stop and tail lamp)

If the lamp bulb does not operate, have the vehicle checked by an authorized Kia dealer.

Rear combination lamp bulb replacement
Type A Type B (1) Stop and tail light (2) Tail light (3) Rear turn signal light (4) Back-up light (5) Rear side marker light ...

Inside lamp
Type A Type B 1. Open the tailgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the s ...

Other Information:

Front Wiper Motor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm. 3 ...

SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 3. Remove the floor console. (Re ...

Categories


Copyright В© www.kisedona.com 2016-2024