As we have more options (ESC, MDPS, SCC, etc.) in the car,
the dashboard now have more information to display depending on the
chosen options.
For this reason, it is necessary to know which options the current vehicle has when replacing the dashboard.
To address this issue, a course of learning based on the
option required for the vehicle when replacing the dashboard should be
carried out.
This is called Variant Coding.
Function
1.
High speed CAN communication (C-CAN)
–
Custom Function : Boarding interlocking sheets, Welcome Light
–
LDWS : Lane Departure Warning System
–
SPAS: Smart Parking Assist System
2.
Low speed CAN communication (MM-CAN)
–
AV : Audio / Video Multimedia information Display
–
TBT : Turn By Turn Navigation Information Display
Sound
Description and function (CAN data receiver)
Welcome
Welcome (Key out and door open/closed state checked by BCM)
Goodbye
Goodbye (Cluster)
Door Open warning
Key
reminder warning (BCM), Vehicle speed is 5km/h or below & IGN
switch is ACC or IGN or engine start & when vehicle speed is below 5
km/h or when the driver side door is opened
Seat belt warning
Driver seat belt warning (BCM)
PAS System warning
PAS sensor fault warning (BCM)
Gear R
PAS warning when shift gear in R (BCM and SPAS)
Parking Brake
Parking brake warning (BCM)
Start button
SSB button warning (SMK)
Rheostat light information
Rheostat warning when select the max or min degree (Cluster)
Smart Key departure
Smart key out warning (SMK)
Non smart key warning (SMK)
Smart Cruise
Change from the conventional cruise to the smart cruise(SCC)
Smart cruise driving information
Smart cruise function cancel (SCC)
conventional cruise
Change from the smart cruise to the conventional cruise(SCC)
Turn signal lamp (Tick)
Turn signal lamp warning (BCM)
Turn signal lamp (Tock)
Turn signal lamp warning (BCM)
Smart key battery low voltage
Warnig when driver push the SSB button with low voltage battery smart key (SMK)
EPB warning
Warning when change from Auto Hold to EPB lock (EPB)
Coolant temperature alarm
When the engine temperature is over 120 °C (EMS)
3.
User Setting Mode (USM)
Setting can be changed by using switches (Menu, UP, Down and
OK button). There are many items (for example, In/Out Seat
Synchronization, In/Out Steering Wheel Synchronization, Auto Door Lock,
Auto Door Lock Deactivate, Head Lamp Escort, Welcome Light, Welcome
Sound, One Touch Turn Signal, Average Fuel Consumption Auto Reset,
Brightness, and Content Setup) that can be set and customized. The
signal flow during setting is as follows.
(1)
UMS settings are set, they are transmitted to BCM.
(2)
BCM transmits the settings via B_CAN to the relevant modules.
(3)
The module completes setting and transmits the modified setting to BCM.
(4)
BCM transmits the final settings via C_CAN to the cluster.
The cluster communicates directly with C-CAN units.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia upper panel.
(Refer to Body - "Center Fascia Panel")
3.
Remove the instrument cluster (A) after loosen ...
Engine Room Under Cover Repair procedures
Removal
Engine Room Front Under Cover
1.
Remove the engine room front under cover (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
2.
Install in the reverse or ...