Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (5) and signal terminal (16).
|
Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Passive Occupant Detection System (PODS-F) Repair procedures
Removal
PODS-F ODU (Occupant Detection Unit)
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning to work.
2.
Remove the front passenger seat assembl ...
Specifications
Specifications
ItemsSpecificationHoodType Rear hinged, gas lifter typeFront DoorStructureFront hinged, frame door structureRegulator systemWire drum typeLocking systemPin-fork systemRear DoorSt ...