Kia Sedona: A/C Pressure Transducer Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / A/C Pressure Transducer Description and Operation
| Description |
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it at high speed or low speed. Engine ECU stops the operation
of the compressor when the temperature of refrigerant line is very high
or very low irregularly to optimize air conditioning system.
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with an L wrench (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
...
A/C Pressure Transducer Repair procedures
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminals “1” and “2”.
2.
Inspect the voltage value to determine whether it is within speci ...
Other Information:
Rear mode selection
Front climate control is :
Rear air blows from the upper vents on the rear ceiling.
Front climate control is :
Rear air blows from the upper vents on the rear ceiling and the lower vents
...
Rear Axle Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damag ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024