Kia Sedona: Tail Gate Back Panel Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Back Panel Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the tail gate trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the license lamp connector and back view camera connector (A).

3.	Loosen the tail gate back panel mounting nuts (A).

4.	Using a screwdriver or remover, remove the tail gate back panel (A).

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

Tail Gate Back Panel Components and Components Location

Component Location 1. Tail gate back panel ...

Tail Gate Lift Repair procedures

Replacement Take care to not let the tailgate fall on you as the lifts are removed. Have a helper hold the tailgate open, or use a secure method to hold it open. ...

Other Information:

Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS), installed on the delivery pipe, measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the s ...

Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...

Kia Sedona: Tail Gate Back Panel Repair procedures

Tail Gate Back Panel Components and Components Location

Tail Gate Lift Repair procedures

Other Information:

Categories