Kia Sedona: Troubleshooting - Lighting System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Troubleshooting

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Troubleshooting

Troubleshooting
Symptom
Possible cause
Remedy
Only one lamp lights on
(All exterior lamps)
Bulb burned out
Replace bulb
Socket, wiring or ground faulty
Repair if necessary
Head lamps do not light on
Bulb burned out
Replace bulb
Ignition fuse (LOW:10A, HIGH:20A) blown
Check for short and replace fuse
Head lamp fuse (15A) blown
Check for short and replace fuse
Head lamp relay faulty
Check relay
Lighting switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Tail lamps and license plate lamp do not light on
Bulb burned out
Replace bulb
Tail lamp fuse (10A) blown
Check for short and replace fuse
Tail lamp relay faulty
Check relay
Lighting switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Stop lamps do not light on
Bulb burned out
Replace bulb
Stop lamp fuse (15A) blown
Check for short and replace fuse
Stop lamp switch faulty
Adjust or replace switch
Wiring or ground faulty
Repair if necessary
Stop lamps do not turn off
Stop lamp switch faulty
Repair or replace switch
Instrument lamps do not light on
(Tail lamps light on)
Rheostat faulty
Check rheostat
Wiring or ground faulty
Repair if necessary
Turn signal lamp flashes only on one side
Bulb burned out
Replace bulb
Turn signal switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Turn signal lamps do not light on
Bulb burned out
Replace bulb
Turn signal lamp fuse (10A) blown
Check for short and replace fuse
Flasher unit faulty
Check flasher unit
Turn signal switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Hazard warning lamps do not light on
Bulb burned out
Replace bulb
Hazard warning lamp fuse (15A) blown
Check for short and replace fuse
Flasher unit faulty
Check flasher unit
Hazard switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Flasher rate too slow or too fast
Lamp wattages are lower or higher than specified
Replace lamps
Flasher unit faulty
Check flasher unit
Back up lamps do not light on
Bulb burned out
Replace bulb
Back up lamp fuse (10A) blown
Check for short and replace fuse
Back up lamp switch (M/T) faulty
Check switch
Transaxle range switch (A/T) faulty
Check switch
Wiring or ground faulty
Repair if necessary
Room lamp does not light on
Bulb burned out
Replace bulb
Room lamp fuse (10A) blown
Check for short and replace fuse
Room lamp switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Front fog lamps do not light on
Bulb burned out
Replace bulb
Front fog lamp fuse (15A) blown
Check for short and replace fuse
Front fog lamp relay faulty
Check relay
Front fog lamp switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Wiring or ground faulty
Repair if necessary
Map lamp does not light on
Bulb burned out
Replace bulb
Room lamp fuse (10A) blown
Check for short and replace fuse
Map lamp switch faulty
Check switch
Wiring or ground faulty
Repair if necessary
Trunk room lamp does not light on
Bulb burned out
Replace bulb
Room lamp fuse (10A) blown
Check for short and replace fuse
Trunk room lamp switch faulty
Check switch
Wiring or ground faulty
Repair if necessary

Rear combination lamp Repair procedures
Removal Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the rear combination lamp cover (A). 3. Remove the rear ...

MTS System
...

Other Information:

Safety chains
You should always attach chains between your vehicle and your trailer. Cross the safety chains under the tongue of the trailer so that the tongue will not drop to the road if it becomes separated ...

CVVT Oil Control Valve (OCV) Specifications
Specification ItemSpecificationCoil Resistance (Ω)9.4 ~ 10.4 [20°C(68°F)] ...

Categories


Copyright © www.kisedona.com 2016-2024