Removal |
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”) |
2. |
Disconnect the fuel sender connector (A) and fuel pump connector (B). |
3. |
Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup. |
4. |
Remove the reservoir cup (B) after releasing the fixing hook (A). |
5. |
Disconnect the ground wire (A). |
6. |
Separate the fuel pump motor and filter after removing the fuel pump motor (A). |
7. |
Remove the fixing clip (A), and then assist pump assembly (B). |
8. |
Separate the electric pump motor (A). |
9. |
Replace new fuel filter. |
Installation |
1. |
Install in the reverse order of removal. |
Rear Upper Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage ...
Heater & A/C Control Unit (DATC) Components and Components Location
Components (1)
Control Panel (AUDIO Type)
Connector Pin Function
Connector Pin NoFunctionConnector Pin NoFunctionA1ILL+ (TAIL)A29CLEAN CIGNAL2SENSOR REF (+5V)30-3-31-4-32-5MODE ACT' ...