Removal |
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”) |
2. |
Disconnect the fuel sender connector (A) and fuel pump connector (B). |
3. |
Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup. |
4. |
Remove the reservoir cup (B) after releasing the fixing hook (A). |
5. |
Disconnect the ground wire (A). |
6. |
Separate the fuel pump motor and filter after removing the fuel pump motor (A). |
7. |
Remove the fixing clip (A), and then assist pump assembly (B). |
8. |
Separate the electric pump motor (A). |
9. |
Replace new fuel filter. |
Installation |
1. |
Install in the reverse order of removal. |
Power Sliding Door (PSD) Control Module Components and Components Location
Components
Connector Pin Information
No.Connector AConnector BConnector CConnector D1-Detent Switch (Left side)Clutch Return (Left side)Logic battery 2-Child Safety Lock Switch (Left side)Quad S ...
Check fuse BRAKE SWITCH (for smart key system)
This warning message illuminates if the brake switch fuse is disconnected.
It means that you should replace the fuse with a new one. If that is not
possible, you can start the engine by pres ...